Table 3-1 . rom monitor commands (continued), Command, Description – Nortel Networks 6300 User Manual
Page 61
3-3
Remote Annex 6300 Hardware Installation Guide
Chapter 3
ROM Monitor Commands
Table 3-1. ROM Monitor Commands (continued)
(continued on next page)
Command
Description
Use
boot [-l] [<file>]
Erases the existing
Flash memory and
copies a new image to
Flash.
Upgrading or
replacing the Flash
image.
config
Displays the current
hardware
configuration and
revision levels.
Identifying your
hardware, memory,
and ROM versions.
console-baud
Changes the console
port’s baud rate.
Configuring the
console port for remote
maintenance.
erase
Erases non-volatile
memory.
Loading a new image
and need to erase the
old image.
help
Displays the list of
ROM Monitor
commands.
Referencing the ROM
monitor commands.
image [-d | <file>]
Displays and/or sets
the load image and
tftp
load dump names.
Loading an image that
differs from the
default.
ipx [-d]
(not supported in
this release)
Displays and sets
EEPROM values
relevant to Novell/IPX
network addressing,
including the IPX
load/dump file server.
Changing Novell/IPX
configuration
parameters. This
command is not used
for this configuration
of the Remote Annex
6300.
lat_key [-d]
Sets the LAT key.
Connecting to a DEC
VMS host.