Nortel Networks 6300 - Manual (Page 42)

Remote Annex 6300 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 6300
2-6
Attaching the Mounting Bracket and Device to the Rack
Attach the mounting bracket to the rack as follows:
1 Position the Remote Annex horizontally, facing forward in the rack.
2 Align the holes in the mounting bracket with the holes in the rack.
3 Insert the mounting screws and tighten the screws to attach the
Remote Annex 6300 to the rack (see
Figure 2-4 ).
Figure 2-4. Attaching the Mounting Bracket and Device to the Rack
Connecting a LAN Using Ethernet
The Remote Annex 6300 supports three types of Ethernet connections:
Thin Ethernet, Thick Ethernet, or Twisted Pair (see
Figure 2-5 ).
Each connection type requires a different connection procedure
described in the following sections. Connect only one type of Ethernet
cabling at one time.
Make sure the Remote Annex 6300 is powered off before
disconnecting or connecting the Ethernet cabling.
CONSOLE 10BASE5 10BASET
ISDN PRI
LINK
10BASE2
115