Power-up and test, 1 reconnect all the cables, including, 2 turn on the unit’s power – Nortel Networks 6300 User Manual
Page 122: 3 set the remote annex 6300 to test mode by pressi, Figure c-4 . setting the remote annex 6300 to test, The ethernet cable, The pri isdn interface cable, The console terminal cable, The power cord, 1reconnect all the cables, including
Remote Annex 6300 Hardware Installation Guide
Appendix C
Modem Carrier Card Upgrade Instructions
C-6
Power-up and Test
To run the Remote Annex 6300 power-up and test sequence:
1
Reconnect all the cables, including:
❑
The Ethernet cable
❑
The PRI ISDN Interface cable
❑
The console terminal cable
❑
The power cord
2
Turn on the unit’s power.
3
Set the Remote Annex 6300 to Test mode by pressing and holding
the
button (located on the front panel) for three seconds
(see
The Remote Annex runs its ROM-resident power-up diagnostics.
Figure C-4. Setting the Remote Annex 6300 to Test Mode
Reset
Reset
Button
Bay Networks
Remote Annex 6300
Xylogics, a Bay Networks Company
32
31
30
29
28
27
26
25
24
23
22
21
20
19
18
17
16
15
Modem Status
14
13
12
11
10
9
8
7
6
5
4
3
2
1
CD
Tx/Rx
13-16 9-12
5-8
1-4
29-32 25-28 21-24 17-20
Modem Config
Status
Test Sync Los
Red
Yel
Blu
Stat
Traf
Setup
Reset
Power
Attn
Network/Status
Ararms
32
31
30
29
28
27
26
25
24
23
22
21
20
19
18
17
16
15
14
13
12
11
10
9
8
7
6
5
4
3
2
1
PRI Channel Status