Nortel Networks 6300 - Manual (Page 45)

2-9 Remote Annex 6300 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 6300
Connecting Thick Ethernet (10Base5) Cable
To connect Thick Ethernet (10Base5) or equivalent transceiver cable,
you must have already installed a 10Base5 Ethernet network cable.
Follow these steps to connect the Remote Annex 6300 to a Thick
Ethernet cable (see
Figure 2-7 ):
1 Make sure the transceiver cable is plugged into the Ethernet
network.
2 Push the slide mechanism on the Remote Annex 6300’s Thick
Ethernet connector to the right and plug in the transceiver cable.
3 Push the slide mechanism to the left to secure the connection.
Figure 2-7. Connecting Thick Ethernet Cable