beautypg.com

2 plug the 8-pin connector into the console port l, Figure 2-10 . connecting a console terminal, 3 turn on the console terminal and set the termina – Nortel Networks 6300 User Manual

Page 48: Figure 2-10. connecting a console terminal -12

background image

Remote Annex 6300 Hardware Installation Guide

Chapter 2

Installing the Remote Annex 6300

2-12

2

Plug the 8-pin connector into the console port located on the back
panel of the Remote Annex 6300 (

Figure 2-10

).

When the connector clicks into place, the connection is secure.

Appendix A

describes the console port’s signal/pin allocation.

Figure 2-10. Connecting a Console Terminal

3

Turn on the console terminal and set the terminal to 9600 baud, eight
data bits, no parity, one stop bit, and XON/XOFF flow control.

The ROM Monitor assumes that this terminal is CRT-based and
displays the backspace (BS) character accordingly. See

Chapter 3

for information on invoking the ROM monitor.

See also other documents in the category Nortel Networks Phones: