Nortel Networks 6300 - Manual (Page 49)

2-13 Remote Annex 6300 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 6300
Connecting the PRI ISDN Interface
A PRI ISDN Interface is used to connect the Remote Annex 6300 to
an ISDN line. Follow the steps in this section to connect the ISDN line
to the PRI ISDN Interface port located on the rear panel of the Remote
Annex 6300.
1 Plug the RJ48C connector located on the PRI ISDN Interface Cable
into the PRI ISDN Interface port located on the rear panel of the
Remote Annex 6300 (see
Figure 2-11 ).
When the connector clicks into place, the connection is secure.
Appendix A describes the PRI ISDN Interface port’s signal/pin
allocation.
Figure 2-11. Connecting the PRI ISDN Interface