Nortel Networks 6300 - Manual (Page 39)

2-3 Remote Annex 6300 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 6300
Attaching the Mounting Bracket to the Remote Annex 6300
Attach the front mounting bracket to the Remote Annex 6300 as
follows:
1 Remove the mounting bracket from its package.
2 Remove three screws from the front of the cover on each side of the
Remote Annex 6300, as shown in
Figure 2-1 . Save these screws; you
will need them later to install the front mounting bracket.
3 Install front mounting bracket to the device using the six screws
previously removed.
4 Tighten the screws to secure the bracket to the device.
Figure 2-1. Attaching the Mounting Bracket to the Remote Annex 6300
Screws
(3 places each side)