Nortel Networks 6300 - Manual (Page 47)

2-11 Remote Annex 6300 Hardware Installation Guide
Chapter 2 Installing the Remote Annex 6300
Connecting a Console Terminal
A console terminal is used to access the ROM Monitor and boot the
Remote Annex 6300 for the first time. Follow the steps in this section
to connect a console terminal to the console port located on the rear
panel of the Remote Annex 6300.
1 Connect the console terminal’s I/O connector to the cable (the
accessory kit includes a cable) using a DB-25 DTE drop adapter
(see
Figure 2-9 ).
Figure 2-9. Connecting the Cable to the DB-25 DTE Drop Adapter