3 verify the remote annex 6300’s hardware configur – Nortel Networks 6300 User Manual
Page 52
Remote Annex 6300 Hardware Installation Guide
Chapter 2
Installing the Remote Annex 6300
2-16
If the ATTN LED is ON or flashing, one of the following failures
has occurred (see
for more details):
❑
Remote Annex hardware failure; contact technical
support.
❑
Network or network interface failure; error message
displays on the console.
If a network or network interface failure occurs, typing
q
accesses the ROM Monitor prompt. Check the network
connection and then see
3
Verify the Remote Annex 6300’s hardware configuration.
At the monitor prompt on the console, type config and press
. The screen display looks similar to this:
This display is typical for T1 versions. For E1,
information, 32 ports will be shown. For versions
without modems, no port or modem information
will be shown.
Return
REVISION/CONFIGURATION INFORMATION
ROM Software Rev:
1002
Board ID: 63
Board Type: RA6300
CPU Type: 486DX2
Ethernet Address: 00-80-2D-02-CE-A9
Memory size: 8 Meg
EEPROM size: 65504
Flash size: 2 Meg
Flash ID: 8989
Available Interfaces (* = selected) ThickNet ThinNet *Twisted Pair
SLC Local DRAM Size: 4 Meg
SLC SRAM Size: 128K
TDM Interface: PRI T1 USA
Revision: VERSION A MGR=1.117
Modem Country Code: 63
Port #
1
2
3
4
5
6
7
8
9
10
11
12
Modem ID
2883
2883
2883
2883
2883
2883
2883 2883
2883
2883
2883
2883
Mod Status
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
Port #
13
14
15
16
17
18
19
20
21
22
23
24
Mod ID
2883
2883
2883
2883
2883
2883
2883 2883
2883
2883
2883
2883
Mod Status
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK
OK