Creating the virtual trunks (ld 14) – Nortel Networks 5100 User Manual

Page 43

IP Peer Networking configuration

For Incoming and Outgoing trunk (ICOG), select Incoming and
Outgoing (IAO).

Set the Access Code for the trunk route (ACOD).

Select the The route is for a virtual trunk route (VTRK) check box.

Type the Zone number of the zone with the ZBRN set to Vtrk for
the new route.
This value must match the values you configure in the Signaling
Server.

Type the Node ID of signaling server of this route (NODE).
This value must match the values you configure in the Signaling
Server.

For Protocol ID for the route (PCID), select SIP H323.

Select the Integrated Services Digital Network option (ISDN)
check box.

For Mode of operation (MODE), select Route uses ISDN
Signaling Link (ISLD).

Select the virtual D-Channel number (DCH).

For Interface type for route (IFC), select Meridian M1 (SL1).

Type the Private Network Identifier (PNI).

Leave the Call type for outgoing direct dialed TIE route (CTYP)
at the default value.
It is best to let NARS/BARS entries determine the NPI/TON for a
number so that the route can be used for multiple call types.

Select the Insert ESN Access Code (INAC) check box.

Leave the other default values as is and click Submit.
The Routes and Trunks screen appears showing the created routes.

—End—

Creating the virtual trunks (LD 14)

The Virtual Trunk TNs that you configure in this procedure cannot overlap
with the ones that you configure for IP Phones.

Enterprise: Common

Solution Integration Guide for Communication Server 1000/Multimedia Communication Server 5100

NN49000-301

01.01

Standard

Release 4.5

27 October 2006

Nortel Networks Confidential