Nortel Networks COOLPIX S1100PJ - Manual (Page 165)

151
Setup Menu
Basi
c Came
ra Setup
B
Notes on Vibration Reduction
• Vibration reduction may take a few seconds to activate after the power is turned on, or the camera
enters shooting mode from playback mode. Wait until the image of the monitor stabilizes before
shooting.
• Due to characteristics of the vibration reduction function, images displayed in the camera’s
monitor immediately after shooting may be displayed blurry.
• Vibration reduction may be unable to completely eliminate the effects of camera shake in some
situations.
• Image processing with electronic vibration reduction may not perform as expected with very
slight or extreme camera shake, even when On (hybrid) is selected.
• Image processing with electronic vibration reduction is not enabled at fast or extremely slow
shutter speeds, even when On (hybrid) is selected.
• Date imprint (A 149) and On (hybrid) for Vibration reduction cannot be applied
simultaneously. When taking pictures with the setting of On (hybrid) for Vibration reduction,
Date imprint is set to Off.
• When On (hybrid) is selected and electronic vibration reduction is activated, the shutter is
automatically released twice when a picture is taken to allow for image processing. Therefore, the
time required to record pictures increases. Shutter sound (
A 152) can be heard only when the
shutter is released the first time and a single picture will be recorded.
h AF Assist
Enable or disable AF-assist illumination, which assists autofocus operation when
the subject is dimly lit.
Tap the bottom tab ( A 143) M Tap z (Setup menu) M h AF assist
Auto (default setting)
AF-assist illumination will be used to assist the focus operation when the subject is
dimly lit. The illuminator has a range of about 3.5 m (11 ft.) at the maximum wide-
angle position and about 2.0 m (6 ft. 6 in.) at the maximum telephoto position.
Note that for some scene modes or focus areas, AF-assist illuminator may not light.
Off
AF-assist illuminator does not light. The camera may be unable to focus under dim
lighting.