Program editing steps – Niles Audio ZR-8630AVZR-8630AV User Manual

Page 78

Edit IR Commands for Source 6: T

ap the

NEXT but

ton until the

SOURCE 5/6 LED is GREEN, and the IR

COMMANDS

LED blinks.

Skip to Step 2.

Edit IR Commands for Source 7: T

ap the

NEXT but

ton until the

SOURCE 7/8 LED is RED, and the IR

COMMANDS

LED blinks.

Skip to Step 2.

Edit IR Commands for Source 8: T

ap the

NEXT but

ton until the

SOURCE 7/8 LED is GREEN, and the IR

COMMANDS

LED blinks.

Skip to Step 2.

Step 2 - Press a Function Button on the Niles R-8

Remote that corresponds to the source-component IR
command you wish to teach. The

ENTER IR LED

lights red.

Step 3 - Using the sour

ce component's factory remote,

teach the IR command. The

ENTER IR LED turns off.

Step 4 - Immediately after capturing the IR

command,

test it by pressing the

TEST IR button. If the sour

component does not respond correctly to the IR com-
mand, try reteaching the command at various dis-
tances from a half-inch (roughly a centimeter and a
quarter) to three feet (almost a meter).

Step 5 - Repeat all steps until you have taught all of

the source-component IR commands.

Step 6 -

Tap the

PROGRAM button t

o exit program-

ming.

PROGRAM EDITING STEPS

SEQUENCE EDITING

o program the control sequences for the source

components:

Step 1 - Press and hold the PROGRAM button.

The

PROGRAM LED lights, the TUNER 1/2 LED

lights, the

SEQUENCE LED blinks, and the ENTER IR

LED is on.

Edit a sequence for Source 3: T

ap the

NEXT button

until the

SOURCE 3/4 LED is RED, and the

SEQUENCE LED blinks.

Skip to Step 2.

Edit a sequence for Source 4: T

ap the

NEXT button

until the

SOURCE 3/4 LED is GREEN, and the

SEQUENCE LED blinks.

Skip to Step 2.

Edit a sequence for Source 5: T

ap the

NEXT button

until the

SOURCE 5/6 LED is RED, and the

SEQUENCE LED blinks.

Skip to Step 2.

Edit a sequence for Source 6: T

ap the

NEXT button

until the

SOURCE 5/6 LED is GREEN, and the

SEQUENCE LED

blinks.

Skip to Step 2.

Edit a sequence for Source 7: T

ap the

NEXT button

until the

SOURCE 7/8 LED is RED, and the

SEQUENCE LED blinks.

Skip to Step 2.

Edit a sequence for Source 8: T

ap the

NEXT button

until the

SOURCE 7/8 LED is GREEN, and the

SEQUENCE LED blinks.

Skip to Step 2.

Step 2 - Press the keys on the Niles R-8 Remote that

correspond to the commands you wish to include in
the sequence.

Enter commands and delays in the order you wish
them to occur. The sequence may include as many as
64 commands and/or delays. To include a delay, use
the Volume + key (1 second) or Volume - key (.5 sec-
ond). The

ENTER IR LED blinks when it receives a

command.

Step 3 -

Tap the

PROGRAM button to exit program

ming.