Niles Audio ZR-8630AVZR-8630AV - Manual (Page 74)

PROGRAM
ENTER
IR NEXT
66
SYSTEM PROGRAMMING STEPS
Step 6 - Press the NEXT button.
If the source component does not respond correctly to the IR command, press again the same Function Button on the Niles
R-8 Remote.
The ENTER IR LED lights RED. Reteach the command and test again. If the sour ce component still does not respond cor-
rectly, try reteaching the command at various distances from a half-inch (roughly a centimeter and a quarter) to three feet
(almost a meter). If it still doesn’t work, see Alternate IR Learning Mode on page 68.
Step 8 - T each the Source 3 IR command.
TUNER 1 2
SOURCE 3 4
SOURCE
POWER OR
DISCRETE "ON"
DISCRETE "OFF" SOURCE
5
7
6
8
IR COMMANDS POWER
PROGRAM
ENTER
IR NEXT
RED LED GREEN LED
The DISCRETE “OFF”
LED turns OFF .
The IR COMMANDS
LED blinks RED.
Step 7 - On the Niles R-8 Remote, press a Function
Button that corresponds to the Source 3 IR command
you wish to teach.
TUNER 1 2
SOURCE 3 4
SOURCE
SOURCE
5
7
6
8
PROGRAM
ENTER
IR
NEXT
RED LED GREEN
The ENTER IR LED lights RED.
TUNER 1 2
SOURCE 3 4
SOURCE
POWER OR
DISCRETE "ON"
DISCRETE "OFF" SOURCE
5
7
6
8
IR COMMANDS POWER
PROGRAM
ENTER
IR
SEQUENCE
NEXT TEST IR
RED LED GREEN LED
The ENTER IR LED turns OFF . Immediately after capturing the IR command, test
it by pressing the
TEST IR button.
Step 9 - Repeat Steps 7 and 8 until you have taught all commands for Sour ce 3.
The ENTER IR
light turns off.