beautypg.com

Installation settings – Niles Audio ZR-8630AVZR-8630AV User Manual

Page 69

background image

INSTALLATION SETTINGS

VOLUME SETTINGS

The ZR-8630A

V has three useful volume features with customizable settings:

Maximum T

urn ON and Source Change Volume Level

Maximum T

urn ON and Source Change Volume prevents a zone from playing too loudly when it turns on or

if its selected source changes.

When a zone turns ON individually, it always turns ON to its last volume setting—unless the last volume
setting is greater than the Maximum Turn ON and Source Change Volume level set in the memory of the
ZR-8630AV. In that case, it turns ON to the Maximum Turn ON and Source Change Volume level.

When a zone selects a new source, the volume setting does not change—unless the zone’s current volume set-
ting is greater than the Maximum Turn ON and Source Change Volume level. In that case, it changes to the
Maximum Turn ON and Source Change Volume level.

The range for Maximum Turn ON and Source Change Volume is 30 through 63. The factory default is 45. To
adjust it up or down, see Changing Volume Settings below.

ALL ON

Volume Level

In response to a system-wide ON command, zones that are OFF turn ON to the

ALL ON Volume Level set in

the memory of the ZR-8630AV. Volume levels in zones that already are ON don’t change during a system- wide
ON command. The range for ALL ON Volume Level is 1 through 63. The factory default is 22. To adjust it up
or down, see Changing Volume Settings below.

Page

Volume Level

When a page occurs, all zones broadcast it at the Page V

olume Level set in the memory of the ZR-8630AV. The

range for PAGE Volume Level is 1 through 63. The factory default is 35. To adjust it up or down, see Changing
Volume Settings below.

Changing

Volume Settings

1.

T

urn the ZR-8630AV ON.

2. Press and hold the PROGRAM button for two seconds, until the LCD display shows "PGM MODE.”

3. Press the T

uner Select button.

The LCD display shows "MxVol #" (for Maximum Turn ON and Source Change Volume Level).

4. Press the Station Scan + button to increase MxV

ol or press the Station Scan - button to decrease MxVol.

5. Press the T

uner Select button or NEXT button to advance to “OnVol #” (for ALL ON Volume Level) and

repeat Step 4 to adjust.

6. Press the T

uner Select button or NEXT button to advance to “PgVol #” (for Page Volume Level) and repeat

Step 4 to adjust.

7. T

ap the PROGRAM button to exit programming.

61