3 set or modify the vpnserver parameters, Modify command, Example – Nortel Networks 608(WL) User Manual
Page 188: Set or modify the vpnserver parameters, Chapter 6
Chapter 6
Advanced Features
E-DOC-CTC-20051017-0169 v0.1
186
6.5.3 Set or modify the vpnserver parameters
modify command
The
ipsec peer vpnserver modify
command sets or modifies the
vpnserver entity parameters.
Example
In this example, the parameters of the previously defined vpnserver entity, named
serv1, are set:
Use the
list
command to verify the results of the operation:
[ipsec peer vpnserver]=>modify
name = serv1
[push_ip] =
disabled
enabled
[push_ip] = disabled
[iprange] = 10.60.11.0/24
[netmask] = 255.255.255.0
[primdns] = 10.60.11.200
[secdns] = 10.60.11.201
[primwins] = 10.60.11.100
[secwins] = 10.60.11.101
[domain] = clients
[xauthpool] =
:ipsec peer vpnserver modify name=serv1 push_ip=disabled iprange=10.60.
11.0/
24 netmask=24 primdns=10.60.11.200 secdns=10.60.11.201 primwins=10.60.1
1.100 secwins=10.60.11.101 domain=clients
[ipsec peer vpnserver]=>
[ipsec peer vpnserver]=>list
[serv1]
Push IP
: disabled
Address Range : 10.60.11.0/24
Netmask
: 255.255.255.0
Primary DNS
: 10.60.11.200
Secondary DNS : 10.60.11.201
Primary WINS
: 10.60.11.100
Secondary WINS: 10.60.11.101
Domain
: clients
XAuth Pool
:
[ipsec peer vpnserver]=>