Nortel Networks 608(WL) - Manual (Page 171)

Chapter 5
Troubleshooting SpeedTouch™ IPSec
E-DOC-CTC-20051017-0169 v0.1 169
Syslog messages The following table shows the syslog messages.
Severity Contents
ERROR unable to delete old SPD entry
ERROR Peer local ID not configured
ERROR unable to delete SPD entry
NOTICE invalid certificate
INFO new phase 2 sa: from
INFO Cert status unknown; no ISAKMP
INFO Cert not usable; no ISAKMP
INFO added SPDB entry: () ->
(if )
INFO added SADB entry: dir() spi()
enc() auth()
INFO connection profile in use
INFO establish request for connection
INFO Cannot create authentication. Maximum licensed number
has already been reached.
INFO Cannot create peer. Maximum licensed number
has already been reached.
INFO peer profile in use
INFO Cannot create connection. Maximum licensed number
has already been reached.
INFO phase <1|2> sa delete: ID(local: remote:)
INFO phase 2 sa delete: from
INFO new phase <1|2> sa: ID(local: remote:)
INFO Cannot create IKE session. Maximum licensed number
has already been reached.
INFO Certificate not found
INFO delete SADB spi(in 0x/ out 0x)
INFO delete SPDB spi(in 0x/ out 0x)
INFO ipsec drop: ->
proto spi seq reason