Nortel Networks 608(WL) - Manual (Page 169)

Chapter 5
Troubleshooting SpeedTouch™ IPSec
E-DOC-CTC-20051017-0169 v0.1 167
5.3 Via the CLI: Debug command group
Traceconfig command The traceconfig command sets the level of debugging messages that are dumped
to the screen. This is shown below:
You can check the Phase 1 and 2 specific information being exchanged during
tunnel setup via following command when you activate the tracing: Press Q>. In the tracing a lot of very detailed protocol information, exchanged during
tunnel setup, is shown. Each tunnel negotiation/rekeying will echo these traces on
the screen. You can stop the trace listing typing . You can clear the
message buffer typing .
[ipsec debug]=>traceconfig level
none
low medium
high
[ipsec debug]=>traceconfig level medium
[ipsec debug]=>