3 set the network descriptor parameters, Modify command, Example – Nortel Networks 608(WL) User Manual
Page 141: Set the network descriptor parameters, Chapter 4
Chapter 4
Configuration via the Command Line Interface
E-DOC-CTC-20051017-0169 v0.1
139
4.6.3 Set the Network Descriptor Parameters
modify command
The
ipsec connection network modify
command sets or modifies the
Network Descriptor parameters.
Example
In this example, the parameters of the previously defined network, named net1, are
set:
In the example above, the network is defined as an IP subnet 10.0.0.0/24. No
protocol or port number are selected. The TAB key was used to show the supported
entries for the proto and port parameters.
Use the
list
command to verify the results of the operation:
[ipsec connection network]=>
[ipsec connection network]=>modify
name = net1
[type] =
address
subnet
range
[type] = subnet
[ip] = 10.0.0.0/24
[proto] =
ah
egp
esp
ggp
gre
hmp
icmp
igmp
pup
rdp
rsvp
tcp
udp
vines
xns-idp
6to4
[proto] =
[port] =
at-echo
at-nbp
at-rtmp
at-zis
auth
bgp
biff
bootpc
bootps
chargen
clearcase
daytime
discard
dns
domain
doom
echo
exec
finger
ftp
...
[port] =
:IPSec connection network modify name=net1
[ipsec connection network]=>
[ipsec connection network]=>list
[net1] : subnet 10.0.0.0/24
[ipsec connection network]=>