Polycom SOUNDPOINT SIP 2.2.0 - Manual (Page 39)

Setting up Your System
3 - 11
Ethernet Menu
The following Ethernet configuration parameters can be modified on the
Ethernet menu:
Syslog Menu
Syslog is a standard for forwarding log messages in an IP network. The term
"syslog" is often used for both the actual syslog protocol, as well as the
application or library sending syslog messages.
Note The Server User and Server Password parameters should be changed from the
default values. Note that for insecure protocols the user chosen should have very
few privileges on the server.
Name Possible Values Description
CDP Enabled, Disabled If enabled, the phone will use CDP. It also reports PoE
power usage to the switch. The default value is Enabled.
VLAN ID Null, 0 through 4094 Phone’s 802.1Q VLAN identifier. The default value is Null.
Note: Null = no VLAN tagging
VLAN Filtering Enabled, Disabled Filter received Ethernet packets so that the TCP/IP stack
does not process bad data or too much data.
Enable/disable the VLAN filtering state.
The default value is Enabled.
Storm Filtering Enabled, Disabled Filter received Ethernet packets so that the TCP/IP stack
does not process bad data or too much data.
Enable/disable the DoS storm prevention state.
The default value is Enabled.
LAN Port Mode 0 = Auto
1 = 10HD
2 = 10FD
3 = 100HD
4 = 100FD The network speed over the Ethernet.
The default value is Auto.
PC Port Mode Auto, 10HD, 10FD, 100HD,
100FD The network speed over the Ethernet.
The default value is Auto.
Note The LAN Port Mode and PC Port Mode parameters are only available on
SoundPoint IP 330, 430, 550, 601, and 650 phones. HD means half duplex and FD
means full duplex.
It is recommended that you leave the LAN and PC parameters set to Auto.