Polycom SOUNDPOINT SIP 2.2.0 User Manual
Page 212
Administrator’s Guide SoundPoint IP / SoundStation IP
A - 100
This flash attributes are defined as follows:
Name
Possible Values
Description
device.set
0 or 1
default = 0
If set to 0, do not use any device.xxx.yyy fields to
set any parameters. Set this to 0 after the initial
installation.
If set to 1, use the device.xxx.yyy fields that have
device.xxx.yyy.set
= 1. Set this to 1 for the initial
installation only.
device.xxx.yyy.set
0 or 1
default = 0
If set to 0, do not use the device.xxx.yyy value.
If set to 1, use the device.xxx.yyy value.
For example, if device.net.ipAddress.set = 1,
then use the contents of the device.net.ipAddress
field.
device.net.ipAddress
dotted-decimal IP address
Phone's IP address.
Note: This field is not used when DHCP client is
enabled.
device.net.subnetMask
dotted-decimal IP address
Phone's subnet mask.
Note: This field is not used when DHCP client is
enabled.
device.net.IPgateway
dotted-decimal IP address
Phone's default router / IP gateway.
Note: This field is not used when DHCP client is
enabled.
device.net.vlanId
Null, 0 to 4094
Phone’s 802.1Q VLAN identifier.
Note: Null = no VLAN tagging
device.net.cdpEnabled
0 or 1
If set to 1, the phone will attempt to determine its
VLAN ID through the CDP.
device.dhcp.enabled
0 or 1
For description, refer to
on page
.
device.dhcp.offerTimeout
1 to 600
Number of seconds the phone waits for secondary
DHCP Offer messages before selecting an offer.
device.dhcp.bootSrvUseOp
t
0 to 3
For descriptions, refer to
on page
device.dhcp.bootSrvOpt
128 to 254 (Cannot be the
same as VLAN ID Option)
device.dhcp.bootSrvOptTy
pe
0 or 1
device.dhcp.dhcpVlanDisc
UseOpt
0 to 2
device.dhcp.dhcpVlanDisc
Opt
128 to 254 (Cannot be the
same as Boot Server
Option)