Polycom SOUNDPOINT SIP 2.2.0 - Manual (Page 130)

Administrator’s Guide SoundPoint IP / SoundStation IP
A - 18
• There is no limitation on the number of R triplet sets in a digit map.
However, a digit map that contains less than full number of triplet sets (for
example, a total of 2Rs or 5Rs) is considered an invalid digit map.
• Using T in the left part of RRR syntax is not recommended. For example,
R0TR322R should be avoided.
This configuration attribute is defined as follows:
Routing
This attribute allows the user to create a specific routing path for outgoing SIP
calls independent of other “default” configurations.
This attribute also includes:
• Server
• Emergency
Attribute Permitted Values Default Interpretation
dialplan.digitmap string compatible with the
digit map feature of
MGCP described in 2.1.5
of RFC 3435. String is
limited to 768 bytes and
30 segments; a comma is
also allowed; when
reached in the digit map,
a comma will turn dial
tone back on;’+’ is allowed
as a valid digit; extension
letter ‘R’ is used as
defined above. [2-9]11
|0T|
+011xxx.T|
0[2-9]xxxxxxxxx|
+1[2-9]xxxxxxxx|
[2-9]xxxxxxxxx|
[2-9]xxxT
When this attribute is
present, number-only dialing
during the setup phase of
new calls will be compared
against the patterns therein
and if a match is found, the
call will be initiated
automatically eliminating the
need to press Send.
Attributes
dialplan.applyToCallLis
tDial ,
dialplan.applyToDirecto
ryDial ,
dialplan.applyToUserDia
l , and
dialplan.applyToUserSen
d control the use of match
and replace in the dialed
number in the different
scenarios.
dialplan.digitmap.timeOut string of positive integers
separated by ‘|’ 3 | 3 | 3 | 3 | 3 | 3 Timeout in seconds for each
segment of digit map.
Note: If there are more digit
maps than timeout values,
the default value of 3 will be
used. If there are more
timeout values than digit
maps, the extra timeout
values are ignored.