Wireless (802.11b/g), Performing advanced configuration – Proxim ORINOCO AP-2000 User Manual

Page 48

Performing Advanced Configuration

stations that may not be able to receive multicast packets at the higher rates; in this case, you should set Multicast
Rate to 1 or 2 Mbits/sec.

Figure 4-6

1 Mbits/s and 11 Mbits/s Multicast Rates

NOTE

There is an inter-dependent relationship between the Distance between APs and the Multicast Rate. In
general, larger systems operate at a lower average transmit rate. The variation between Multicast Rate and
Distance Between APs is presented in the following table:

The Distance Between APs must be set before the Multicast Rate, because when you select the Distance
Between APs, the appropriate range of Multicast values automatically populates the drop-down menu. This
feature is not available if you are using an ORiNOCO ComboCard or a non-ORiNOCO client with the AP.

Wireless (802.11b/g)

You can configure the following radio parameters for an 802.11b/g AP:

NOTE

You must reboot the Access Point before any changes to these parameters take effect.

•

Operational Mode: An 802.11b/g wireless interface can be configured to operate in the following modes:
–

802.11b mode only: The radio uses the 802.11b standard only.

–

802.11g mode only: The radio is optimized to communicate with 802.11g devices. This setting will provide
the best results if this radio interface will only communicate with 802.11g devices.

1.0 Mbit/s

2.0 Mbits/s

5.5 Mbits/s

11 Mbits/s

Large

yes

Medium

yes

Small

yes

Minicell

yes

Microcell

yes