Proxim ORINOCO AP-2000 - Manual (Page 158)

158
Using the Command Line Interface (CLI)
– VLAN/SSID Parameters - Enable the configuration of multiple subnetworks based on VLAN ID and SSID
pairs.
– Security Profile Table - Configure Security Profiles that define allowed security modes (wireless clients), and
encryption and authentication mechanisms.
• Other Parameters
– IAPP Parameters - Enable or disable the Inter-Access Point Protocol.
– SpectraLink VoIP Parameters (802.11b and bg Modes Only) - Enable or disable SpectraLink Voice over IP
feature.
System Parameters
Name Type Values Access CLI Parameter
System Group N/A R system
Name DisplayString User Defined RW sysname
Location DisplayString User Defined RW sysloc
Contact Name DisplayString User Defined RW sysctname
Contact E-mail DisplayString User Defined RW sysctemail
Contact Phone DisplayString User Defined
max 254 characters RW sysctphone
FLASH Backup Interval Integer 0 - 65535 seconds RW sysflashbckint
Flash Update 0
1 RW sysflashupdate
System OID DisplayString N/A R sysoid
Descriptor DisplayString System Name, flash
version, S/N, bootloader
version R sysdescr
Up Time Integer dd:hh:mm:ss
dd – days
hh – hours
mm – minutes
ss – seconds R sysuptime
Emergency Restore to defaults Resets all parameters to
default factory values RW sysresettodefaults
Note: You must enter the
following command twice to
reset to defaults:
set sysresettodefaults 1