Proxim ORINOCO AP-2000 - Manual (Page 173)

173
Using the Command Line Interface (CLI)
NOTE
The Heartbeat parameters are advanced settings not available via the HTTP interface. When Heartbeat is
enabled, the AP periodically sends a message to the Syslog server to indicate that it is active. The frequency
with which the heartbeat message is sent depends upon the setting of the Heartbeat Interval.
Syslog Host Table
The table described below configures the Syslog hosts that will receive message from the AP. You can configure up to
ten Syslog hosts.
Bridge Parameters
Spanning Tree Parameters
Spanning Tree Priority and Path Cost Table
Syslog Lowest Priority
Logged Integer 1 – 7
1 = LOG_ALERT
2 = LOG_CRIT
3 = LOG_ERR
4 = LOG_WARNING
5 = LOG_NOTICE
6 = LOG_INFO (default)
7 = LOG_DEBUG RW syslogpritolog
Heartbeat Status Integer enable (1)
disable (2) (default) RW sysloghbstatus
Heartbeat Interval (seconds) Integer 1 – 604800 seconds;
900 sec. (default) RW sysloghbinterval
Name Type Values Access CLI Parameter
Syslog Host Table Table N/A R sysloghosttbl
Table Index Integer 1 – 10 N/A index
IP Address IpAddress User Defined RW ipaddr
Comment (optional) DisplayString User Defined RW cmt
Status (optional) Integer enable
disable
delete RW status
Name Type Values Access CLI Parameter
Spanning Tree Group N/A R stp
Spanning Tree Status Integer enable (default)
disable RW stpstatus
Bridge Priority Integer 0 – 65535
32768 (default) RW stppriority
Maximum Age Integer 600 – 4000
(in 0.01 sec intervals;
i.e., 6 to 40 seconds)
2000 (default) RW stpmaxage
Hello Time Integer 100 – 1000
(in 0.01 sec intervals;
i.e., 1 to 10 seconds)
200 (default) RW stphellotime
Forward Delay Integer 400 – 3000
(in 0.01 sec intervals;
i.e., 4 to 30 seconds)
1500 (default) RW stpfwddelay
Name Type Values Access CLI Parameter
Spanning Tree Table Table N/A R stpbl
Table Index (Port) N/A 1 – 15 R index