Proxim ORINOCO AP-2000 - Manual (Page 145)

145
Using the Command Line Interface (CLI)
[Device-Name]>set snmpv3privpasswd (SNMPv3 privacy password)
[Device-Name]>reboot 0
CAUTION !
Proxim strongly urges you to change the default passwords to restrict access to your network devices to
authorized personnel. If you lose or forget your password settings, you can always perform the
Reset to
Factory Default Procedure .
Set Network Names for the Wireless Interface
[Device-Name]>set wif netname wireless interface>
[Device-Name]>show wif
Figure A-13 Results of “show wif” CLI command for an AP
Enable and Configure TX Power Control for the Wireless Interface(s)
The TX Power Control feature lets the user configure the transmit power level of the card in the AP at one of four
levels:
•
100% of the maximum transmit power level of the card
• 50%
• 25%
• 12.5%
Perform the following commands to enable TX Power Control and set the transmit power level:
[Device-Name]>set txpowercontrol enable
[Device-Name]>set wif currenttxpowerlevel
Allowed values are: 1 (100%), 2 (50%), 3 (25%), 4 (12.5%)
Configure SSID (Network Name) and VLAN Pairs, and Profiles
Perform the following command to configure an SSID/VLAN pair, and to assign a Security Profile and RADIUS Profiles
to it.
[Device-Name]>set wifssidtbl ssid vlanid <-1 to 1094>
ssidauth acctstatus secprofile Nmuber> radmacprofile radeapprofile Authentication Profile Name> radacctprofile radmacauthstatus
aclstatus denynonencrypted