Proxim ORINOCO AP-2000 - Manual (Page 176)

176
Using the Command Line Interface (CLI)
Rogue Access Point Detection (RAD) Parameters
Hardware Configuration Reset
The Hardware Configuration Reset commands allows you to enable or disable the feature and to change the password
to be used for configuration reset during boot up.
VLAN/SSID Parameters
Server IP Address or
Name IpAddress
DisplayString User defined (enter an
IP address if seraddrfmt
is ipaddr or a name if set
to name; up to 254
characters if using a
name) RW ipaddr
Port (optional) Integer User Defined
1812 (default) RW port
Shared Secret DisplayString User Defined
6-32 characters W ssecret
Response Time
(optional) Integer 1 – 10 seconds
3 (default) RW responsetm
Maximum
Retransmissions
(optional) Integer 0 – 4
3 (default) RW maxretx
RADIUS MAC Address
Format Integer dashdelimited
colondelimited
singledashdelimited
nodelimiter RW radmacaddrformat
RADIUS Accounting
Inactivity Timer Integer32 1-60 minutes RW radaccinactivetmr
Authorization Lifetime Integer32 900-43200 seconds W radauthlifetm
RADIUS Accounting
Update Interval Integer32 10-3600 minutes RW radacctupdinterval
VLAN ID vlanID RW radvlanid
Name Type Values Access CLI Parameter
Rogue Access Point Detection (RAD) Group N/A R rad
Status Integer enable
disable (default) RW radstatus
Scan Interval Integer 15-1440 (minutes) RW radscanint
Interface Bitmask Interface
Bitmask 4 (WiF A), 8 (WiF B), or 12
(both). RW radifbitmask
Name Type Values Access CLI Parameter
Hardware Configuration Reset
Status Integer Enable (1)
Disable (2) R hwconfigresetstatus
Configuration Reset Password DisplayString User Defined RW configresetpasswd
Name Type Values Access CLI Parameter
VLAN Group N/A R vlan
Status Integer enable
disable (default) RW vlanstatus
Management ID VlanId -1 (untagged)
or 1-4094 RW vlanmgmtid