Proxim ORINOCO AP-2000 - Manual (Page 152)

152
Using the Command Line Interface (CLI)
Configure MAC Access Control
Setup MAC (Address) Access Control
[Device-Name]>set macaclstatus enable
[Device-Name]>set macacloptype
[Device-Name]>reboot 0
Add an Entry to the MAC Access Control Table
[Device-Name]>set macacltbl macaddr status enable
[Device-Name]>show macacltbl
Disable or Delete an Entry in the MAC Access Control Table
[Device-Name]>set macacltbl status
[Device-Name]>show macacltbl
NOTE
For larger networks that include multiple Access Points, you may prefer to maintain this list on a centralized
location using the RADIUS parameters (see
Set RADIUS Parameters ).