Configure the ap as a dhcp server, Configure the dns client, Maintain client connections using link integrity – Proxim ORINOCO AP-2000 User Manual
Page 148: Change your wireless interface settings, Using the command line interface (cli)
148
Using the Command Line Interface (CLI)
NOTE
Performing Advanced Configuration
for more information on these settings.
Configure the AP as a DHCP Server
NOTE
You must have at least one entry in the DHCP Server IP Address Pool Table before you can set the DHCP
Server Status to Enable.
[Device-Name]>set dhcpstatus disable
[Device-Name]>set dhcpippooltbl 0 startipaddr
endipaddr
[Device-Name]>set dhcpgw
[Device-Name]>reboot 0
CAUTION
!
Before enabling this feature, confirm that the IP address pools you have configured are valid addresses on the
network and do not overlap the addresses assigned by any other DHCP server on the network. Enabling this
feature with incorrect address pools will cause problems on your network.
Configure the DNS Client
[Device-Name]>set dnsstatus enable
[Device-Name]>set dnsprisvripaddr
Figure A-14 Results of “show dns” CLI command
Maintain Client Connections using Link Integrity
[Device-Name]>show linkinttbl (this shows the current links)
[Device-Name]>set linkinttbl <1-5 (depending on what table row you wish to address)>
ipaddr
the link down>
[Device-Name]>set linkintstatus enable
[Device-Name]>show linkinttbl (confirm new settings)
[Device-Name]>reboot 0
Change your Wireless Interface Settings
for information on the parameters listed below. Dual-radio APs use index 3 for Slot A and index 4 for
Slot B.