Pioneer AVIC-Z1 - Manual (Page 93)

91
Cha
pt
er
10
Modif
y
in
g
the Gene
ra
l Set
tings f
o
r N
a
vigation Functions
NA
V
I
Chapter 10
Modifying the General Settings for Navigation Functions
• For safety reasons, these functions are not
available while your vehicle is in motion.
To enable these functions, you must stop
in a safe place and put on the parking
brake before setting your route (see page
18 Interlock for details).
Entering the Settings Menu
1
Press the MENU button to display the
navigation menu.
2
Touch [Settings] to display the Settings
menu.
3
Change the setting.
Adjusting each item
➞ Page 91 to 98
❒ This section describes the details of the
setting for each item. Settings marked with
an asterisk (*) show that they are default or
factory settings.
Setting the Volume Related to
the Guidance and Phone
The sound volume for the navigation can be set.
You can separately set the volume of the route
guidance and the beep sound.
1
Touch [Settings] in the navigation menu,
then touch [Volume].
2
Touch [+] or [–] to set their volume.
On this screen, you can operate the following
items.
Guidance
This setting controls the guidance volume of
navigation.
When you set this to , a guidance is out-
put. When you set this to , no guidance is
output.
Beep
This setting controls the beep tone volume of
navigation.
Phone Ringtone
This setting controls the incoming ring tone
volume.
Phone Voice
This setting controls the incoming voice vol-
ume.
❒ The Phone Ringtone and Phone Voice
adjustments are related to the cellular
phone featuring BT technology. No adjust-
ment is needed when the cellular phone
featuring BT technology is not connected.
❒ Volume of the audio source is adjusted by
the VOL (
/ ) button of the navigation
system.
3
To finish the setting, touch [OK].
Customizing the Regional Set-
tings
Changing the language for navi-
gation guidance and menu
You can select the language to be used for the
navigation function. (Once you change the lan-
guage, the program restarts.)
• Once the installation of the program starts,
do not stop the engine of your vehicle and
do not switch off the navigation system
until the installation is completed and the
map of your surroundings appears.