Paradyne 9820-2M - Manual (Page 200)

Setting Up Network Health for FrameSaver Devices
11-2 9820-A2-GB20-20 June 2000
For additional information about installing, accessing, and managing FrameSaver
SLV devices through Concord’s Network Health, and for information about
applicable reports, refer to:
H Network Health Installation Guide to help you install the application.
H Network Health User Guide to help you get started using the application.
H
Network Health Reports Guide to help you understand and use Frame Relay
reports.
H Network Health – Traffic Accountant Reports Guide to help you understand
and use Traffic Accountant reports.
Installation and Setup of Network Health
Refer to the Network Health Installation Guide for installation instructions, and
follow the instructions applicable to your network platform. Once Network Health
is installed, you need to set up the application so it will support FrameSaver units.
Each Network Health application provides a different set of functions, called a
module. Each module used requires a separate license to gain access to those
features and functions. Make sure you license the Poller application so you can
poll SLV units and collect data.
To use this application:
1. Discover network elements, units, and interfaces in the network.
2. Configure the Network Health applications, then save them.
3. Organize elements into groups for reporting purposes.
4. Set up and run reports.
Setup and operation information is contained in the Network Health User Guide.
The sections that follow address only the minimal procedural steps needed once
you have access to the applications.
See the Network Health User and Reports Guides for additional startup
information and a full discussion of the application’s features and how to use
them.