Paradyne 9820-2M - Manual (Page 11)

ix 9820-A2-GB20-20 June 2000
About This Guide
Purpose and Intended Audience
This document contains information needed to properly set up, configure, and
verify operation of FrameSaver SLV in-line monitors. It is intended for system
designers, engineers, administrators, and operators.
Document Organization
Section Description
Chapter 1 About FrameSaver SLV In-Line Monitors. Identifies how
FrameSaver SLV in-line monitors fit into Paradyne’s SLM
solution, and describes the features of these units.
Chapter 2 User Interface and Basic Operation. Shows how to
navigate the user interface.
Chapter 3 Configuration Procedures. Shows how to access and save
configuration options.
Chapter 4 Configuration Options. Describes the configuration options
available on the units.
Chapter 5 Security and Logins. Shows how to control access to the
FrameSaver SLV and setting up logins.
Chapter 6 Monitoring. Shows how to display unit identification
information and perform file transfers, as well as how to
display and interpret status and statistical information.
Chapter 7 FTP Operation. Shows how to use File Transfer Protocol to
upgrade system software and transfer collected data.
Chapter 8 Troubleshooting. Provides device problem resolution,
alarm, and other information, as well as troubleshooting
and test procedures.