Paradyne 9820-2M - Manual (Page 128)

Monitoring
6-18 9820-A2-GB20-20 June 2000
Health and Status Messages
The following table provides Health and Status messages that apply to the
FrameSaver unit.
Table 6-11. Health and Status Messages (1 of 2)
Message What It Indicates
Auto-Configuration Active Auto-Configuration feature is active, which allows
automatic configuration and cross-connection of
DLCIs as they are reported by the network LMI.
Back-to-Back Mode Active The operating mode has been configured for
back-to-back operation (
Main Menu
→
Control
→
Change Operating Mode).
The FrameSaver unit can be connected to another
FrameSaver unit without a frame relay switch
between them.
This feature is useful for product demonstrations
or for a point-to-point configuration using a leased
line.
Backup Active (Model 9820-45M) A backup has been established
and data is flowing over an alternate DLCI.
Clock Out of Range at Network 1 A valid network data port rate cannot be detected
because the:
H Unit is trying to detect a valid port rate.
H Rate detected is greater than the highest port
rate supported by the unit.
– FrameSaver SLV 9820 rates:
56/64 or 128 kbps in 56 or 64 kbps
increments
– FrameSaver SLV 9820-2M rates:
64 – 2048 kbps in 64 kbps increments
– FrameSaver SLV 9820-8M rates:
1024 – 8192 kbps in 8 kbps increments
– FrameSaver SLV 9820-45M rates:
1024 – 44210 kbps in 8 kbps increments
CTS down to Port-1 Device (Models 9820, 9820-2M, 9820-8M) The user data
port CTS control lead on the FrameSaver unit is
off.
DLCI nnnn Down,
frame relay link 1, 2
The DLCI for the specified frame relay link is down.
DTR Down from Port-1 Device The DTR control lead from the device connected to
the user data port is deasserted.
1 nnnn indicates a DLCI number of 16 through 1007.
2 frame relay link is one of the following:
– Net1-FR1. The frame relay link specified for the network interface, Network 1.
– Port-1. The frame relay link associated with the user data port.