Paradyne 9820-2M - Manual (Page 121)

Monitoring
6-11 9820-A2-GB20-20 June 2000
Device Messages
These messages appear in the messages area at the bottom of the screens.
All device messages are listed in alphabetical order.
Table 6-9. Device Messages (1 of 5)
Message What It Indicates What To Do
Access level is n ,
Configuration is
Read-only.
The user’s access level is 2
or 3; the user is not
authorized to change
configurations. No action needed.
Already Active The test selected is already
running. H Allow test to continue.
H Select another test.
H Stop the test.
Cannot Modify TS
Management Link The Management PVC you
are attempting to modify is
defined as the TS
Management Link. H No action needed.
H Modify a different PVC.
Cannot save - no
Level 1 Login IDs You are attempting to save
a configuration which has
no Level 1 Login ID. Create a Login ID with an access
level of 1, then save the
configuration.
Command Complete Configuration has been
saved or all tests have
been aborted. No action needed.
Connection Refused Two menu-driven user
interface sessions are
already in use when a
Telnet session was
attempted. Wait and try again.
DLCI in connection.
Delete connection first You tried to delete a DLCI
that was part of a
connection. H No action needed, or
H Delete the connection, then
delete the DLCI.
DLCI Number Already
Exists The number entered is a
duplicate of an existing
DLCI record. Enter another DLCI number.
DLCI Number
Reserved The number entered is a
special excluded DLCI in
the product. Enter another DLCI number.
File Transfer Complete
(Seen at an FTP
terminal.)
A file transfer was
performed successfully. Switch to the newly downloaded
software.
See Changing Software in
Chapter 7, FTP Operation.