Paradyne 9820-2M - Manual (Page 134)

Monitoring
6-24 9820-A2-GB20-20 June 2000
Table 6-14. PVC Connection Status (2 of 2)
Field What It Indicates Status
DLCI 16 to 1007 For standard DLCIs.
Identifies an individual link/
connection embedded within a
DLCI.
EDLCI 0 to 62 For multiplexed DLCIs only.
Identifies an individual link/
connection embedded within a
DLCI.
Status Identifies whether the physical
interfaces, LMIs, and DLCIs are all
enabled and active for this PVC
connection.
Active 1 H The PVC is currently active.
Inactive H The PVC is inactive because:
– Alarm conditions and network
and SLV communication
status indicate that data
cannot be successfully
passed.
– The unit has disabled the
interface or frame relay link
due to internal operating
conventions.
– Activation of an alternate
virtual circuit is not warranted;
that is, no alarm condition on
the primary destination link
has been detected.
Disabled H The PVC cannot be activated
and is essentially disabled as a
result of how the unit was
configured. Possible causes:
– The physical interface at one
or both ends of the PVC is/are
disabled.
– The frame relay link on one or
both ends of the PVC is/are
disabled.
Invalid H Some portion of the PVC
connection is not fully configured.
1 For the circuit to be active, both Source and Destination Statuses must be Active.