Panasonic AV-HS450N - Manual (Page 14)

14
1. Installation
1-3. How to install the option boards
The option boards are installed in the mainframe.
For details, refer to the operating instructions of the option board concerned.
 Be absolutely sure to ask your dealer to do the job of installing or removing the option boards.
 Before installing or removing an option board, turn off the power, and disconnect the power plug.
 Before coming into physical contact with the option board, touch your hand to metal that has been grounded
to discharge the static electricity in your body.
A safe way to proceed is to wear an anti-static wrist strap.
The option board may be damaged if you touch the board with static still in your body.
 Avoid damage to the option board by not dropping it or subjecting it to strong shocks or vibrations.
 After removing an option board, be absolutely sure to attach the blank panel.
 When installing or removing an option board, take care not to hurt yourself on the edges or metal parts of the
board.
Notes
Turn off the power of the mainframe, and disconnect the power cord.
Loosen the two screws of SLOT A or SLOT B at the back of the mainframe, and remove the blank panel.
Screw
Blank panel
Screw
SLOT B
SLOT A