Panasonic TQBJ0350 - Manual (Page 58)

DISPLAY OPTION menu
58
- ENGLISH
Settings
RGB IN
(Only RGB input)
Change this setting to change the input impedance of
the synchronous signal input.
Press ▲▼ to select [RGB IN]. 1 )
Press button. 2 )
The [ z RGB IN] screen will be displayed.
Press ▲▼ to select [RGB1 SYNC 3 )
TERMINAL] or [RGB2 SYNC
TERMINAL].
Press ◄► to switch.
4 )
The setting will change as follows each time z
◄► is pressed.
LOW HIGH
LOW Input impedance is set to [LOW].
HIGH Input impedance is set to [HIGH].
DVI-D IN
Change this setting if video does not display normally
when the projector and an external device are
connected via DVI.
Press ▲▼ to select [DVI-D IN]. 1 )
Press button. 2 )
The [ z DVI-D IN] screen will be displayed.
Press ▲▼ to select [DVI EDID]. 3 )
Press ◄► to switch [DVI EDID]. 4 )
The setting will change as follows each time z
◄► is pressed.
EDID3 EDID1 EDID2 : PC
EDID3
Switch between fine settings for a
moving image and for a still image.
EDID1
Mainly select this when an external
device (DVD player, etc.) for
outputting video signals of a moving
image system is connected to DVI-D
IN.
EDID2 : PC
Mainly use this when an external
device (PC, etc.) for outputting video
signals of a still image system is
connected to DVI-D IN.
Press ▲▼ to select [DVI SIGNAL 5 )
LEVEL].
Press ◄► to switch [DVI SIGNAL 6 )
LEVEL].
The setting will change as follows each time z
◄► is pressed.
0-255 : PC 16-235
0-255 : PC
Select this when, for example,
an external device (PC, etc.) is
connected via the DVI terminal
output.
16-235
Select this when, for example, an
external device (DVD player, etc.)
is connected via the HDMI terminal
output using a conversion cable.
Note
The optimal setting differs depending on the output z
setting of the connected external device. Refer to the
instruction manual of the external device.
If the setting is changed, the data for plug and play z
changes. For the plug and play compatible resolutions,
refer to “List of compatible signals” ( Æ page 88).
HDMI IN
Change this setting if video does not display normally
when the projector and an external device are
connected via HDMI.
Press ▲▼ to select [HDMI IN]. 1 )
Press button. 2 )
The [ z HDMI IN] screen will be displayed.
Press ◄► to switch [HDMI SIGNAL 3 )
LEVEL].
The setting will change as follows each time z
◄► is pressed.
0-1023 64-940
0-1023
Select this when, for example, a DVI
terminal output of an external device
(PC etc.) is connected to HDMI IN
using a conversion cable, etc.
64-940
Select this when, for example,
an HDMI terminal output of an
external device (DVD player, etc.) is
connected to HDMI IN.
Note
The optimal setting differs depending on the output z
setting of the connected external device. Refer to the
instruction manual for the external device.
The displayed HDMI signal level is the value when the z
input is 30 bit.