beautypg.com

Powering up the projector, Making adjustment and selection, Powering on/off – Panasonic TQBJ0350 User Manual

Page 33: English

background image

Powering ON/OFF

ENGLISH -

33

Basic Operation

Powering up the projector

Connect the supplied power cable.

1 )

(AC100-120 V 50-60 Hz)

Press the [ | ] marked side of the

2 )

MAIN POWER switch to turn on the

power.

The POWER indicator lamp on the projector will

flash in red. After a short period, the indicator will

illuminate and the projector will enter standby

mode.

Press POWER ON.

3 )

[Power indicator] lamp illuminates in green and

soon the image is projected on the screen.

Note

If the projector is powered up at about 0 °C, a warm-up

z

period of approximately 5 minutes may be necessary to

start projection. indicator lamp lights up during

the warm-up period. When the warm-up is completed,

indicator lamp turns off and the image is

projected on the screen.

If the temperature of the operating environment is low

z

and warm-up takes more than 5 minutes, the projector

will judge that a problem has occurred and the power

will be turned off automatically. If this happens, increase

the temperature around the projector so that it is 0 °C or

higher, and then turn on the MAIN POWER switch and

the POWER ON ( | ) switch once more.

With [ECO] setting in [Standby mode] (

z

Æ

page 65), When

switch on the projector, projection will start about 10

seconds late.

If projection was stopped last time by using the DIRECT

z

POWER OFF function, it can be started by setting the

MAIN POWER switch to the “ I ” (ON) position.

When you power up the projector or switch the signal

z

input, a high-frequency driving noise may be heard. This

is not a failure.

Making adjustment and

selection

It is recommended that the images are projected

continuously for at least 30 minutes before the focus

is adjusted.

Select and set the projection scheme

4 )

of [INSTALLATION] and [COOLING

CONDITION] settings in [PROJECTOR

SETUP] menu.
Select the input signal by pressing

5 )

button (,

, ,

).
Adjust the tilt of the main unit in front

6 )

and rear or right and left.
Press button if the

7 )

input signal is RGB signal.

2)

1)

6)

5)

7)

4)

3)

7)

3)

4)

5)

This manual is related to the following products: