Panasonic TQBJ0350 - Manual (Page 48)

48
- ENGLISH
Settings
POSITION menu
See z “Navigating through the menu”
( Æ page 40).
See z “MAIN MENU” and “SUB MENU”
( Æ page 41).
SHIFT
This function allows the user to adjust the raster
position vertically or horizontally if the position of the
image projected on the screen is displaced even
when the projector is properly aligned with the screen,
and the internal test patterns are correctly framed.
Press ▲▼ to select [SHIFT]. 1 )
Press button. 2 )
The [SHIFT] screen will be displayed. z
Press ▲▼◄► to adjust the position. 3 )
J
For vertical (up and down)
adjustment
Operation Adjustment
Press ▲.
The picture
position
moves up.
Press ▼.
The picture
position
moves down.
J
For horizontal (right and left)
adjustment
Operation Adjustment
Press ►.
The picture
position
moves to the
right.
Press ◄.
The picture
position
moves to the
left.
ASPECT
This changes the aspect ratio of the projected image.
This changes the aspect ratio for the screen range
selected with [SCREEN SETTING]. Set [SCREEN
SETTING] first. ( Æ page 55)
Press ▲▼ to select [ASPECT]. 1 )
Press ◄► or button. 2 )
The [ASPECT] individual adjustment screen will z
be displayed.
Press ◄► to switch [ASPECT]. 3 )
The setting will change as follows each time z
◄► is pressed.
VID AUTO *1
DEFAULT S1 AUTO *3 VID AUTO (PRI.) *3
AUTO *2
THROUGH
HV FIT
16 : 9
V FIT H FIT 4 : 3
VIDEO/S-VIDEO (NTSC) only *1 :
RGB1/RGB2 (480i, 480p) only *2 :
S-VIDEO (NTSC) only *3 :
J
DEFAULT
Pictures are displayed without changing the aspect
ratio of the input signals.
J
VID AUTO
The projector identifies the video ID (VID)
embedded in the picture signals and displays the
picture by automatically switching the screen sizes
between 4 : 3 and 16 : 9. This function is effective
for the NTSC signal input.
J
AUTO
The projector identifies the video ID (VID)
embedded in the picture signals and displays the
picture by automatically switching the screen sizes
between 4 : 3 and 16 : 9. This function is effective
for the 480i/480p signal input.
J
S1 AUTO
The projector identifies the S1 signal and displays
the picture by automatically switching the screen
sizes between 4 : 3 and 16 : 9. This function is
effective for S-VIDEO NTSC signals.