Panasonic TQBJ0350 - Manual (Page 50)

POSITION menu
50
- ENGLISH
Settings
Press ▲▼ to select [INTERLOCKED]. 3 )
Press ◄► to switch [INTERLOCKED]. 4 )
OFF
The [VERTICAL] and
[HORIZONTAL] settings are used
as the vertical and horizontal zoom
ratios respectively.
ON
The zoom ratio is set to the [BOTH]
setting.
This allows the pictures to be
zoomed at equal vertical and
horizontal ratios.
Note
When [ASPECT] is set to [THROUGH], [ZOOM] will not z
appear.
When other than [DEFAULT] is selected for [ASPECT], z
the [MODE] selection setting will not appear.
CLOCK PHASE
Clock phase adjustment achieves the best image
when the screen flickers or halos are observed around
contours.
Press ▲▼ to select [CLOCK PHASE]. 1 )
Press ◄► or button. 2 )
The [CLOCK PHASE] individual adjustment z
screen will be displayed.
Press ◄► to adjust the level. 3 )
The value changes from 0 to 31. Adjust so that z
the amount of interference is at a minimum.
Note
The CLOCK PHASE may not be adjusted, depending on z
the signal.
No optimal value may be obtained if the output of the PC z
to which the signal input is applied is unstable.
No optimal value may be obtained if the total number of z
dots is not correct.
The [CLOCK PHASE] can be adjusted only when RGB z
signal input is applied with RGB1 and RGB2 IN.
KEYSTONE
If the projector is aligned non-perpendicularly to the
screen, or if the projection screen has an angled
surface, you can correct keystone.
Press ▲▼ to select [KEYSTONE]. 1 )
Press button. 2 )
Select the desired adjustment item. 3 )
Press ◄► to adjust. 4 )
J
KEYSTONE
J
SUB KEYSTONE
J
LINEARITY
Note
When [KEYSTONE] setting is set, displayed menu or z
startup logo might be projected outside of the actual
image area.
You can correct the distortion ±40 ° from the plane. For z
a better quality image, installing the projector with a
minimum of distortion is recommended.
Some distortion may be retained for lens shift adjustment. z
The result of the keystone correction will affect the aspect z
ratio and the size of the image.