Panasonic TQBJ0350 - Manual (Page 34)

Powering ON/OFF
34
- ENGLISH
Basic Operation
Powering off the projector
Press POWER STANDBY ( 1 ) ).
Press ◄► to select [OK] and press 2 )
(ENTER).
(or press POWER STANDBY ( )
again.)
The projection of the image stops, and [Power
indicator] lamp of the main unit lights up orange.
(The cooling fan keeps running.)
Wait until the power indicator lamp of 3 )
the main unit turns to red (i.e., until
the cooling fan stops).
Press the [
4 ) ] marked side of the
(MAIN POWER) switch to remove all
power from the projector.
Note
In the cooling state after the power is turned off, the z
lamp will not light up even if the power is turned on.
To light up the lamp, turn on the power supply again
when the lamp has been cooled sufficiently. Failure
to observe this may shorten the lamp life.
The projector consumes approximately 15 W (120 V z
and 240 V mode) power.
(STANDBY MODE: [NORMAL])
Direct power off function
The power supplied internally causes the cooling fan
to continue operating and cool off in the event that
the power has failed or even after the power cord is
accidentally disconnected immediately after the power
has been turned off.
Note
When the lamp has been cooled by the direct power off z
function, it sometimes takes longer than usual for the
lamp to light up again.
While the cooling fan is operating, do not place the z
projector inside a box or bag.
If projection was stopped by using the DIRECT POWER z
OFF function, it can be started by setting the MAIN
POWER switch to the “ I ” (ON) position.
1) 3)
2)
1)
2)
4)