Panasonic TQBJ0350 - Manual (Page 40)

40
- ENGLISH
Settings
Menu Navigation
Menus are extensively used for configuring, adjusting or reconfiguring the projector.
Navigating through the menu
J
Operating procedure
Press 1 )
[MAIN MENU] appears on the screen.
Press ▲▼ to select the desired item. 2 )
The selected item is highlighted in orange.
Press button to establish 3 )
your selection.
The submenu for the selected option will now
open.
0
Press ▲▼ button to highlight the 4 )
desired adjustment item, then press
◄► to change or adjust the parameter
value.
For some items, an individual adjustment screen
containing a bar scale will appear as shown in the
diagram below when ◄► is pressed.
0
Note
Press z
Some menu items may not be valid for certain signal z
formats applied to the projector. The menu items that
cannot be adjusted or used are shown in gray characters,
and they cannot be selected.
If no button is pressed for approx. 5 seconds while the z
individual adjustment screen is displayed, the screen will
return to the previous page.
J
Resetting to the factory default
If an adjustment item is selected and
button is pressed, the adjustment value will return
to the factory default setting.
Press
0
Note
You cannot reset all the settings at a time to the factory z
default settings. To reset all the settings to the factory
defaults, refer to “INITIALIZE” of “PROJECTOR SETUP
menu” ( Æ 70 page).
Some menu items are not available to reset by pressing z
button. Adjust each menu item manually.
The triangle mark under the bar indicates factory default z
setting and the square indicates the current setting.
The triangle mark position varies by the selected input
signals.
SUB MENU
MENU SELECT
ENTER
PICTURE
POSITION
ADVANCED MENU
DISPLAY LANGUAGE
DISPLAY OPTION
PROJECTOR SETUP
TEST PATTERN
SIGNAL LIST
SECURITY
NETWORK
MAIN MENU
SUB MENU
MENU SELECT
ENTER
PICTURE
POSITION
ADVANCED MENU
DISPLAY LANGUAGE
DISPLAY OPTION
PROJECTOR SETUP
TEST PATTERN
SIGNAL LIST
SECURITY
NETWORK
MAIN MENU
ENTER SUB MENU
MENU SELECT
SHIFT
ASPECT
ZOOM
CLOCK PHASE
GEOMETRY
POSITION
DEFAULT
OFF
ADJUST
CONTRAST
ADJUST
CONTRAST
Default setting
Current setting