Panasonic TQBJ0350 - Manual (Page 49)

POSITION menu
ENGLISH -
49
Settings
VID AUTO (PRI.)
J
The projector identifies the abovementioned
VID or S1 signals and displays the picture by
automatically choosing the screen sizes of 4 : 3
or 16 : 9 according to the VID if it is detected or
S1 signals if a VID is not detected. This function is
effective for S-Video NTSC signals.
J
THROUGH
Pictures are displayed without changing the
resolution of the input signals.
J
16 : 9
When standard signals *4 are input, the pictures
are displayed with the aspect ratio converted to
16 : 9. When wide signals are input *5 , the pictures
are displayed without changing the aspect ratio.
J
4 : 3
When standard signals *4 are input, the pictures
are displayed without changing the aspect ratio.
When wide signals are input *5 and [4:3] is
selected with [SCREEN FORMAT], the aspect
ratio is changed to 4:3. If [4:3] is not selected with
[SCREEN FORMAT], the pictures are reduced so
that they will be in the 4:3 screen without changing
the input aspect ratio.
J
H FIT
The display will use the full width of the screen
range selected with [SCREEN FORMAT]. When
signals have a vertical aspect ratio that is larger
than the screen aspect selected with [SCREEN
FORMAT], the pictures will be displayed with their
bottom areas cut off.
J
V FIT
The display will use the full height of the screen
range selected with [SCREEN FORMAT].
J
HV FIT
The pictures are displayed in the full screen range
selected with [SCREEN FORMAT]. If the aspect
ratios of the input signals and screen range differ,
conversion to the screen aspect set with [SCREEN
FORMAT] is performed and then the pictures are
displayed.
Standard signals are input signals with an aspect *4 :
ratio of 4 : 3 or 5 : 4.
Wide-screen signals are input signals with an *5 :
aspect ratio of 16:10, 16 : 9, 15 : 9 or 15 : 10.
Note
Some size modes are not available for certain types of z
input signals. For NTSC signals, [DEFAULT] cannot be
selected.
If an aspect ratio which is different from the aspect ratio z
for the input signals is selected, the pictures will appear
differently from the originals. Be careful of this when
selecting the aspect ratio.
If using this projector in places such as cafes or hotels to z
display programs for a commercial purpose or for public
presentation, note that adjusting the aspect ratio or using
the zoom function to change the screen pictures may
be an infringement of the rights of the original copyright
owner for that program under copyright protection laws.
If conventional (normal) 4 : 3 pictures which are not z
wide-screen pictures are displayed on a wide screen,
the edges of the pictures may not be visible or they may
become distorted. Such pictures should be viewed as
with an aspect ratio of 4 : 3 in the original format intended
by the creator of the pictures.
ZOOM
This adjusts the size of the projected pictures.
Press ▲▼ to select [ZOOM]. 1 )
Press button. 2 )
The [ZOOM] screen will be displayed. z
Press ▲▼ to select [VERTICAL]/ 3 )
[HORIZONTAL], and press ◄► to
adjust.
J
When [ASPECT] is set to
[DEFAULT]
Press ▲▼ to select [MODE]. 1 )
Press ◄► to switch [MODE]. 2 )
INTERNAL
Zoom area is the factory default
setting of [SCREEN FORMAT] in
[SCREEN SETTING].
FULL
Enlarges the size of the pictures
using the whole of the display area
selected with [SCREEN FORMAT].