Linear DUAL 824 User Manual
Page 45
43
SYSTEM REPORTING CODES
✦ Refer to the System Reporting Codes table to
view/edit the reporting codes for the keypad
FIRE and EMERGENCY buttons and for each of
the three Control Panel conditions. The factory
settings are listed, along with a blank area to
write in the new installation values.
STEPS #261-266
Any value from 0-99 can be programmed for
each event using these steps (enter “0” to stop
an event from reporting).
FORCE ARMING REPORTING CODE
✦ The factory set reporting code for force arming is
“65” (Code 574 with Ademco).
STEP #258 Any value from 0-99 can be programmed for this
event using this step (0 = no report).
✎ NOTE: For force arming reporting, force arming
reports must be enabled. See Page 41.
DURESS REPORTING CODE
✦ The factory set reporting code for Duress is “66”
(Code 121 with Ademco).
STEP #259 Any value from 0-99 can be programmed for this
event using this step (0 = no report).
✎ NOTE: For duress code reporting a keypad duress
code must be programmed. See Page 34.
SYSTEM REPORTING CODES
STEP #
PROGRAMMING FUNCTION
POSSIBLE
4 BY 2 VALUES
FACTORY
4 BY 2 VALUES
ADEMCO VALUE
INSTALLATION
4 BY 2 VALUE
258
FORCE ARMING REPORT CODE
0 - 99
65
574
259
DURESS REPORT CODE
0 - 99
66
121
261
SYSTEM FIRE REPORT CODE
0 - 99
68
110
262
SYSTEM EMERGENCY REPORT CODE
0 - 99
69
120
263
SYSTEM TEST/CANCEL REPORT CODE
0 - 99
70
406
264
SYSTEM LOW BATTERY RESTORAL REPORT CODE
0 - 99
71
R302
265
SYSTEM LOW BATTERY CODE
0 - 99
73
E302
OPENING & CLOSING REPORTING CODES TABLE
USER CODE
4 x 2 CLOSING
(ARMING) CODE
4 x 2 OPENING
(DISARMING) CODE
ADEMCO CLOSING
(ARMING) CODE
ADEMCO OPENING
(DISARMING) CODE
MASTER USER CODE1
74
82
R401 C000
E401 C000
RESTRICTED USER CODE #1
75
83
R401 C001
E401 C001
RESTRICTED USER CODE #2
76
84
R401 C002
E401 C002
RESTRICTED USER CODE #3
77
85
R401 C003
E401 C003
RESTRICTED USER CODE #4
78
86
R401 C004
E401 C004
RESTRICTED USER CODE #5
79
87
R401 C005
E401 C005
PAGE ALERT USER CODE
(DIALS PAGE NUMBER ONLY, NO CODES REPORTED)
REMOTE/HARDWIRE ARM (SENSOR FCN. 9) & QUICK ARM
81
R407 C007
REMOTE/HARDWIRE DISARM (SENSOR FCN. 9)
89
E407 C007
PROGRAMMING
STEPS #261 - 266
ENTERS STEP NUMBER
0 - 99 FOR SYSTEM
REPORTING CODE
STORES VALUE - 1 BING
PROGRAMMING STEP #258
ENTERS STEP NUMBER
0 - 99 FOR FORCE ARMING
REPORTING CODE
STORES VALUE - 1 BING
PROGRAMMING STEP #259
ENTERS STEP NUMBER
0 - 99 FOR DURESS CODE
STORES VALUE - 1 BING
Opening & Closing Reporting Codes Table
System Reporting Codes Table