Linear DUAL 824 - Manual (Page 38)

36
✦ To perform any of the advanced programming
steps, the system must be in the Setup Mode.
✦ Each programming function is performed with
similar keystrokes. After the system is in Setup
Mode, enter the programming step number and
press HOME, then enter the new value and press
AWAY. For reference, follow the fi gures next to the
programming steps.
✴ If the new value is accepted, a “Bing” will sound. If the
new value is not accepted, a “Double Buzz” will sound.
SETUP MODE
1. Start with the system in Test Mode (Setup Mode
cannot be reached from any other mode).
2. From Test Mode, enter the master user code then
press TEST.
✎ NOTE: Only the master user code can be used to
put the system into the Setup Mode. The restricted
user codes cannot access Setup Mode, only Code
Mode.
✴ A “Gong” and fi ve “Beeps” will sound, signaling that the
system is in Setup Mode.
3. After programming changes are complete, press
the OFF key for three seconds to exit Setup
Mode.
✎ NOTE: If the system is left unattended in Setup
Mode, it will automatically switch back to Off Mode
after three minutes.
14. COMMUNICATOR PROGRAMMING
ENTERS PROGRAM STEP
NUMBER TO MODIFY
STORES NEW VALUE
General Communicator Programming Table
START IN TEST
MASTER
USER
CODE
1 GONG & 5 BEEPS
(SETUP MODE)
GENERAL COMMUNICATOR OPTIONS
STEP # PROGRAMMING
FUNCTION
POSSIBLE
VALUES
FACTORY
VALUE
INSTALLATION
VALUE
76 2-WAY AUDIO 0= NONE; 1 = LISTEN; 2 = 2-WAY MANUAL; 3 = 2-WAY FULL DUPLEX 0
78 VOICE RESPONSE FROM KEYPAD SPEAKER
0 = VOICE RESPONSE DISABLED
1 = VOICE RESPONSE ENABLED
0
100 REMOTE PROGRAMMING LOCKOUT 0 = UNLOCK; 1 = LOCK 0
101 CALL LIMITER 0 = OFF; 1 = FIVE CALLS PER ARMING PERIOD 0
103 DIALING DELAY 0 = NO DELAY; 1 = 30 SECOND DELAY 0
104 DIALING METHOD 0 = TONE; 1 = PULSE 0
107 COMMUNICATOR ENABLE 0 = COMMUNICATOR OFF; 1 = COMMUNICATOR ON 0