KORG MP-10 PRO - Manual (Page 152)

148 Part 8: The Microphone
sync signal will come from MIDI . When the MIDI source is selected, you
can set the beat unit with the R (Ratio) pop-up menu .
7. Use the High Frequency Damp pop-up menu to activate a low-pass filter
for the repetitions .
8. Touch the SAVE command to save the settings to a Voice Processor Preset
(more info below) .
9. Press the EXIT button to return to the main screen .
Adding reverb to the microphones (MIC1/2)
On both MIC 1 and MIC 2, you can add ambient reverb . The reverb is the same
for both microphones, but you can set the level on each microphone separately .
You can turn this effect on/off quickly, by using the FX button on the control
panel .
1. Press the MIXER button to access the Mixer Menu .
2. Touch the VOICE P . Preset to access the Voice Processor Preset section .
3. Touch the FX button to go to the FX page .