KORG MP-10 PRO - Manual (Page 136)

132 Part 8: The Microphone
Removing any low-frequency pop and rumble (MIC1)
On MIC 1, you can activate a low-cut filter to allow for a cleaner signal from
the microphone, by “cutting out” pops, floor rumble and mic handling noise.
1. Press the MIXER button to access the Mixer Menu .
2. Touch the VOICE P . Setup to access the Voice Processor Setup section .
3. Touch the SETUP button to go to the Setup page .
4. Touch the Low Cut pop-up menu, and choose one of the available filters.
5. Touch the SAVE command to save the settings to a Voice Processor Setup
(more info below) .
6. Press the EXIT button to return to the main screen .
Automatically levelling dynamics through compression (MIC1)
On MIC 1, compression can even-out the dynamic level of your voice .
1. Press the MIXER button to access the Mixer Menu .
2. Touch the VOICE P . Setup to access the Voice Processor Setup section .