Sun Microsystems Sun Fire X4100 - Manual (Page 196)

4-66 Sun Fire X4100 and Sun Fire X4200 Servers Service Manual • June 2006
Note – The Service Action Required LEDs on the front panel and back panel blink
when a power supply is unplugged. See Section C.1, “External Status Indicator LEDs”
on page C-1 for the LED locations and descriptions.
3. Remove the power supply:
a. Grasp the power supply handle and push the thumb latch toward the center of
the power supply. See FIGURE 4-62 .
b. While continuing to push on the latch, use the handle to remove the power
supply from the chassis.
FIGURE 4-62 Removing a Power Supply
Installation is the reverse of this procedure.
Note – When installing a new power supply, press it into the bay until the thumb
latch clicks, indicating that it is locked.