Sun Microsystems Sun Fire X4100 - Manual (Page 183)

Chapter 4 Maintaining the Sun Fire X4200 Server 4-53
FIGURE 4-45 Opening the PCI Card Latches
c. Pull the PCI cards out of the PCI slots. Ensure that each PCI card's rear
connector panel is released from the tabs on the chassis rear panel.
d. Pivot the PCI card latches back to their closed positions.
7. Remove the Graphics Redirect and Service Processor (GRASP) board:
a. Disconnect any external cables from the GRASP board’s connectors.
b. Squeeze the plastic standoff that protrudes through the GRASP board to press
the standoff’s locking tabs. See FIGURE 4-46 .
If you have difficulty pressing the locking tabs with your fingers, you can use a
pair of long-nosed pliers.