Figure 4-57 – Sun Microsystems Sun Fire X4100 User Manual
Page 192
4-62
Sun Fire X4100 and Sun Fire X4200 Servers Service Manual • June 2006
The slots for the PCI cards are detected by the system BIOS during bootup in the
order described in
Section 2.3.2.1, “PCI Card Slot Booting Priority” on page 2-5
Note –
Before you install a card, consult the manufacturer's documentation for
system requirements and configuration information for your specific PCI card.
FIGURE 4-57
Sun Fire X4200 Designation and Speeds of PCI Slots
5. Remove any existing PCI card from the slot, or go to
if the slot is empty:
a. Disconnect any external cables that are attached to the PCI card.
b. Working from the rear of the chassis, pivot open the PCI card latch that covers
the PCI card’s rear connector panel. See
.
FT1
FM0
FT1
FM1
FT1
FM2
FT0
FM0
FT1
FM1
FT1
FM2
CPU1
CPU0
Front panel of server
PCI1 = PCIX 133 MHz
PCI2 = PCIX 66 MHz
PCI3 = PCIX 66 MHz
PCI4 = PCIX 66 MHz
PCI0 = PCIX 100 MHz
0
1
4 3 2
PCI slots 0 - 4