Sharp MX-C401 - Manual (Page 275)

2-39
COPIER
Contents
Enter the paper size of the bypass tray
When the [Custom Size] key is touched, the paper size entry screen appears.
Touch the [X] key and enter the horizontal dimension of
the paper with the
keys, and then touch the [Y]
key and enter the vertical dimension. When finished,
touch the [OK] key.
7
Select the bypass tray.
(1) Touch the paper size key of the bypass tray.
(2) Touch the [OK] key.
8
Press the [COLOR START] key or the [BLACK & WHITE START] key.
Scanning begins.
• If the originals were placed in the document feeder tray, the originals are copied.
• If you placed the originals on the document glass, scan each page one page at a time.
When using sort mode, change originals and press the [START] key. Repeat until all pages have been scanned and then
press the [Read-End] key. (For the second original and following originals, use the same [START] key as you did for the
first original. )
To cancel scanning of the original and copying...
Press the [STOP] key (
).
Paper Select
Paper Tray Bypass Tray
OK
Plain
Plain
Plain
2. 5½x8½
8½x11
3. 8½x14
4. 8½x11
1.
Plain
8½x11 Plain
(1) (2)
OK
OK
(5 1/2~14)
inch
(5 1/2~8 1/2)
inch
14 X
Y 8 ½
Bypass Tray Type/Size Setting
Size Input
X14 Y8½
X14 Y8½
X14 Y8½
AB
Inch
Stored custom paper sizes appear in the keys on the left side of the screen. Custom paper sizes are stored in the system
settings. For details, see "
Paper Tray Settings " (page 7-13) in "7. SYSTEM SETTINGS". If the key for the size that you wish
to enter appears, touch that key.